EFIKA 5K2 The Small Revolution Compact. Width: 118mm Length: 153mm Height: 38mm Efficient. Only a mere 4.1 Watt of power consumption (1080mW by CPU, 3 Watt by 128MB RAM). A complete system with graphics card and harddisk consumes less than 20 Watt of power. Flexible. Despite the small size, you can make use of IDE and USB devices. Also, EFIKA supports PCI/AGP extension cards. Silent. No active cooling required, thus fully silent operation. Due to the lack of a fan, there is one less system component which might fail because of abrasion. This should result in an increased system stability.

The EFIKA 5K2 is a performance evaluation board based around the MPC5200B PowerPC System-on-Chip (SoC) from Freescale Semiconductor.

Specifications are as follows:

• Freescale MPC5200B PowerPC SoC up to 400MHz
• 128MB DDR RAM
• 44-pin IDE connector
• 10/100Mbit/s Ethernet
• 2x USB ports
• 1x RS232 Serial port
• Stereo Audio out, Microphone and Line-input
• PCI/AGP riser slot

Supported Operating Systems: Currently Linux (e.g. Debian GNU/Linux and MorphOS 2.0 are supported. Please visit the official EFIKA web site to obtain the necessary files to install Debian GNU/Linux on the EFIKA (Debian Installer, pre-compiled kernel and modules, kernel source tarball). When purchasing an EFIKA board together with a 2.5" HDD at our store, you'll get Debian GNU/Linux installed on the hard drive.

A trial version of MorphOS 2.0 can be downloaded from the MorphOS Team website. When purchasing an EFIKA board together with a 2.5" HDD at our store, you'll also get an unregistered trial version of MorphOS 2.0 installed on the hard drive.