USB-Controller for Amiga 1200 compatible clockports
Technical data:
compatible with USB 1.1 and USB 2.0 specification (no highspeed mode)
integrated 4-port hub
all ports are protected against overvoltage and short circuit
integrated power management on port by port base
power saving 3.3V technology
compatible with all 68030/040/060 and PPC turbo cards
no mechanical problems with Amiga 1200 bus boards
compatible with all Amiga 1200 tower housings
standard Amiga 1200 clockport connector
works with all Amiga 1200 compatible clockports
(the A600 memory expansion
A604
even features a dedicated clockport for Subway with 60% speed gain)
Software:
integration into AmigaOS via system conform drivers
comfortable control of commodity driver by hotkeys
driver for USB mouse, keyboard, serial and parallel interface
further drivers (webcam, digicam) also by third companies under development
Package contents:
1 Subway USB controller card
1 10cm clockport flat ribbon cable
2 holding plates with two USB connectors each
1 detailed installation manual
1 disk with driver software
System requirements:
Amiga OS 3.1 or higher
Processor 68030 (25 MHz) or higher
100% compatible Amiga 1200 clockport
power supply with 2.0 Ampere minimum on 5V (each used USB port
will use a maximum of 500mA, depending on connected device)
(The alternative USB stack
ANAIIS
allows to use the Subway module with Amiga OS 1.1+ on a mere 68000/~7 MHz.
This stack is not officially supported, though.)
Package contents:
Mister Wong
Digg
LinkArena
