We are on vacation and our shop is closed until April 28, 2014. You can still
place orders during this time, but please have a little patience. (Please note
that there is no support available until we are back in the office.)
We wish you a Happy Easter!
The Small Revolution
Only a mere 4.1 Watt of power consumption (1080mW by CPU,
3 Watt by 128MB RAM). A complete system with graphics card
and harddisk consumes less than 20 Watt of power.
Despite the small size, you can make use of IDE and USB devices.
Also, EFIKA supports PCI/AGP extension cards.
No active cooling required, thus fully silent operation.
Due to the lack of a fan, there is one less system component
which might fail because of abrasion. This should result in an
increased system stability.
The EFIKA 5K2 is a performance evaluation board based around the MPC5200B
PowerPC System-on-Chip (SoC) from Freescale Semiconductor.
Specifications are as follows:
- Freescale MPC5200B PowerPC SoC up to 400MHz
- 128MB DDR RAM
- 44-pin IDE connector
- 10/100Mbit/s Ethernet
- 2x USB ports
- 1x RS232 Serial port
- Stereo Audio out, Microphone and Line-input
- PCI/AGP riser slot
Supported Operating Systems:
Currently Linux (e.g.
Debian GNU/Linux and
are supported. Please visit the
official EFIKA web site
to obtain the necessary files to install Debian GNU/Linux on the
EFIKA (Debian Installer, pre-compiled kernel and modules, kernel source
tarball). When purchasing an EFIKA board together with a 2.5" HDD
at our store, you'll get Debian GNU/Linux installed on the hard drive.
A trial version of MorphOS 2.0 can be downloaded from the
MorphOS Team website.
When purchasing an EFIKA board together with a 2.5" HDD
at our store, you'll also get an unregistered trial version
of MorphOS 2.0 installed on the hard drive.
EFIKA Image Gallery: